Print Page | Close Window

ARD racing seat unit rsv 04>

Printed From: rsvr.net Forums
Category: General Chat
Forum Name: Racing Talk
Forum Description: Racing your Aprilia or a track day addict. Let's hear about it. Watch Motogp etc ? discuss here.
URL: http://www.rsvr.net/forum_posts.asp?TID=4373
Printed Date: 27 Mar 2026 at 02:04
Software Version: Web Wiz Forums 12.07 - https://www.webwizforums.com


Topic: ARD racing seat unit rsv 04>
Posted By: jools
Subject: ARD racing seat unit rsv 04>
Date Posted: 22 Sep 2009 at 22:20

Can anyone who uses a racing seat unit from ARD tell me the knack of fitting it. Ive tried quite a few times and just cannot get it to fit easily, the front bits which sits under the tank (both sides) keeps either scratching my tank or the frame when i try to fit it. Im Not that confident in bending the front of the seat unit out as it starts to make that awful cracking noise. As a result The rear of the unit wont go pass the aluminium frame (middle where original seat unit is bolted to). Would i have to relocate the starter solunoid for an easier fit ??

The racing seat unit that i have been using before i trashed it, is a shorter unit from the USA which uses the original plastic/carbon which fits on the tank and under the seat, and its an absolute doddle to fit and remove . 
I know the ARD unit will fit but there is obviously only one way in which to fit it, of which i have not worked out yet. Jools



Replies:
Posted By: badger
Date Posted: 23 Sep 2009 at 21:47
I am sure it was the regulator i moved mate not the solenoid, i had to trim and do some cutouts as shown to allow fitment, after these cutouts were done it fitted with a little bit of fiddling




Posted By: jools
Date Posted: 26 Sep 2009 at 13:57
Thanks for that, i,ll give it a bash. Cheers Jools



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.07 - https://www.webwizforums.com
Copyright ©2001-2024 Web Wiz Ltd. - https://www.webwiz.net