FAQ Register Login |
Crank flywheel lapping |
Post Reply |
Author | |
Mack 1
L Plates Joined: 11 Jan 2020 Location: Plymouth Status: Offline Points: 5 |
Post Options
Thanks(0)
Posted: 20 Jan 2020 at 16:13 |
Would it be worth centre punching around the stator end of the crank as this is the second time it's slipped. Loctite green used. Thought about a second hand flywheel I think it's good money after bad. Gen 1- 18000 on the clock
Owned since new.
|
|
Prsv
Premium Member Joined: 29 Jan 2016 Location: Fareham Status: Offline Points: 555 |
Post Options
Thanks(0)
|
Was the bolt torque correct and lock tight on threads not taper.
Edit just checked workshop manual, torque 130 n-m , 95.88 ft-lb, loctight 648
|
|
Mack 1
L Plates Joined: 11 Jan 2020 Location: Plymouth Status: Offline Points: 5 |
Post Options
Thanks(0)
|
All correct torque the keyway is a bit shot so need to stop the woodruff key from moving not Jb or 648.when I took the flywheel off the key was in the rotor slot which is not good. So the key is moving which is putting out timimg So need to get some strong metal compound.
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |