rsvr.net Forums Homepage
Forum Home Forum Home > General Chat > Technical info
  New Posts New Posts RSS Feed - Gen 2 updated Temp sensor
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Gen 2 updated Temp sensor

 Post Reply Post Reply
Author
Message
Spoonz View Drop Down
Admins Group
Admins Group


Joined: 11 Feb 2008
Location: North Devon
Status: Offline
Points: 10726
Post Options Post Options   Thanks (0) Thanks(0)   Quote Spoonz Quote  Post ReplyReply Direct Link To This Post Topic: Gen 2 updated Temp sensor
    Posted: 23 Jan 2015 at 11:01
Later Gen 2 bikes use a Nipon denso sensor, but the early bikes use a Bosch version.

The Bosch sensors can give false overtemp indications that cause the ECU to go into "Limp" mode.

You need an updated connector that you can splice into the harness allowing the use of the improved Nipondenso sensor.

The connector is p/n AP8127776
Nippon denso sensor p/n AP0274040

The new sensor Is Green, the Old Bosch type is blue if you want to spot which you have on the bike. (left side or rear cylinder on a Gen 2)
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.03
Copyright ©2001-2019 Web Wiz Ltd.

This page was generated in 0.324 seconds.